The PCBA splitter is to separate the PCBA boards together, which is a necessary equipment in the Small home pcba processing factory.

　　In the production process of Small home pcba, due to the improper operation of the production personnel or the quality of the material, bad pcba boards often occur, and the bad pcba boards need to be repaired at this time. There are generally PCBA maintenance engineers in Small home pcba factories. When repairing the board, it is necessary to follow a certain maintenance process.

　　The process of Small home pcba repair is:

　　1. Visual inspection of Small home pcba

　　Mainly check whether the Small home pcba has obvious bad appearance.

　　2. Measure all POWER

　　Mainly measure whether the power supply is short-circuited to ground.

　　3. Poor power-on test of Small home pcba

　　Use the test fixture DOUBLE CHECK after power-on.

　　4. Repair according to the bad phenomenon

　　Repair according to the bad phenomenon and the circuit principle. You can refer to the project to provide maintenance work instructions.

　　5. Self-inspection after maintenance of Small home pcba

　　After maintenance, the maintenance part needs to be self-checked.

　　6. Test fixture test

　　Use a test fixture to check whether the PCBA is repaired OK.

　　7. Full visual inspection

　　Full inspection of repaired Small home pcba products. By repairing the defective PCBA board, the scrap of the board can be reduced and the production cost of the factory can be reduced.